Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER
RM1880E _53 Suspension _013224 REAR SUSPENSION _0068552 REAR SHOCK ABSORBER N

REAR SUSPENSION  REAR SHOCK ABSORBER  DISPOSAL  


PROCEDURE

Hide 1.DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY LH

F052451
2.615,0.25 2.979,0.542 0.365,0.292 10 false *a
*a Approximately 115 mm


HINT:

Use the same procedure for the other rear shock absorber.


a.

Fully extend the shock absorber piston rod and fix the shock absorber in place at an angle in a vise or similar tool.


b.

Using a drill or similar tool, slowly make a hole approximately 115 mm (4.52 in.) from the top end of the shock absorber and discharge the gas inside of it.

NOTICE:
·

The gas is colorless, odorless and harmless.

·

Since the discharged gas may cause chips to fly off, cover the drill with a cloth when making a hole.