Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER
RM1880E _53 Suspension _013224 REAR SUSPENSION _0068552 REAR SHOCK ABSORBER A

REAR SUSPENSION  REAR SHOCK ABSORBER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL REAR SHOCK ABSORBER ASSEMBLY LH

a.

Install the 3 retainers, 2 cushions, bracket and a new lock nut to the shock absorber.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


b.

Install the shock absorber to the frame with the 2 bolts.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


Hide 2.TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH

a.

Install 2 new bushes and the 2 retainers to the shock absorber.


b.

Temporarily install the shock absorber to the axle housing with the nut.


Hide 3.INSTALL REAR WHEEL

Torque:
110 N*m (1122 kgf*cm, 81 ft.*lbf)

Hide 4.STABILIZE SUSPENSION

a.

Lower the vehicle.


b.

Press down on the vehicle several time to stabilize the suspension.


Hide 5.TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH

a.

Tighten the bolt.

Torque:
82 N*m (836 kgf*cm, 60 ft.*lbf)