Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM
RM1880E _54 Brake _013226 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0068558 ANTI-LOCK BRAKE SYSTEM U

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  TERMINALS OF ECU  


TERMINAL OF ECU


C122186
0.167,0.083 0.542,0.396 0.375,0.313 10 *a
*a Component without harness connected
(Skid Control ECU [Brake Actuator Assembly])


Terminal No. (Symbol) Terminal Description
1 (+BS) ABS solenoid power supply
2 (GND1) Ground
8 (FL-) Front LH wheel speed signal input
9 (FL+) Front LH wheel speed signal input
10 (STP) Stop light switch input
11 (RL+) Rear LH wheel speed signal input
12 (RL-) Rear LH wheel speed signal input
13 (WA) ABS warning light output
14 (D/G) Diagnosis tester communication line
15 (TS) Signal check input
16 (TC) Diagnosis input
18 (PKB) Parking brake switch input
23 (+BM) ABS motor relay power supply
24 (GND2) Ground
25 (IG1) Skid control ECU (Brake actuator assembly) power supply
30 (FR-) Front RH wheel speed signal input
31 (FR+) Front RH wheel speed signal input
33 (RR+) Rear RH wheel speed signal input
34 (RR-) Rear RH wheel speed signal input


TERMINAL INSPECTION


C117862
1.5,0.583 1.917,0.833 0.417,0.25 0.125,0.104 0.396,0.313 0.271,0.208 10 false *a 1.594,0.635 1.979,0.875 0.385,0.24 10 false A13
*a Front view of wire harness connector
(to Skid Control ECU [Brake Actuator Assembly])


a.

Disconnect the skid control ECU (brake actuator assembly) connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
A13-1 (+BS) - Body ground W-R ABS solenoid power supply Always 11 to 14 V
A13-2 (GND1) - Body ground W-B Ground Always Below 1 Ω
A13-10 (STP) - Body ground G-W Stop light switch input Brake pedal depressed 8 to 14 V
Brake pedal released Below 1.5 V
A13-18 (PKB) - Body ground L-O Parking brake switch input
·

Ignition switch ON

·

Parking brake applied


Below 1.5 V
·

Ignition switch ON

·

Parking brake released


10 to 14 V
A13-23 (+BM) - Body ground R ABS motor relay power supply Always 11 to 14 V
A13-24 (GND2) - Body ground W-B Ground Always Below 1 Ω
A13-25 (IG1) - Body ground B Skid control ECU (Brake actuator assembly) power supply Ignition switch ON 11 to 14 V

If the result is not as specified, there may be a malfunction on the wire harness side.