1.CHECK FRONT SPEED SENSOR
Check the speed sensor.
Under any of the following conditions, replace the sensor with a new one.
The surface of the sensor is cracked, dented or chipped.
The connector is scratched, cracked or damaged.
The sensor has been dropped.
| *a | Component without harness connected
(Front Speed Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
|---|---|
| 1 - 2 | 0.65 to 1.8 kΩ |
| 1 - Body ground | 10 kΩ or higher |
| 2 - Body ground | 10 kΩ or higher |
If the result not as specified, replace the speed sensor.
Check the speed sensor signal after replacing the speed sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE).