Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR
RM1880E _54 Brake _013226 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0068561 REAR SPEED SENSOR G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  INSPECTION  


PROCEDURE

Hide 1.CHECK REAR SPEED SENSOR

a.

Check the speed sensor.

i.

Under any of the following conditions, replace the sensor with a new one.

·

The surface of the sensor is cracked, dented, or chipped.

·

The connector is scratched, cracked, or damaged.

·

The sensor has been dropped.



ii.
F100578
1.448,1.479 1,1.76 1,1.76 0.76,1.76 true 1.917,1.469 2.198,1.802 2.198,1.802 2.354,1.802 true 1.469,3.656 1.135,4.156 1.135,4.156 0.896,4.156 true 1.896,3.656 2.156,4.063 2.156,4.063 2.292,4.063 true 0.385,0.563 0.75,0.854 0.365,0.292 10 false *A 0.385,2.896 0.906,3.146 0.521,0.25 10 false *B 0.417,1.677 1,2.01 0.583,0.333 10 false RL+ 0.552,4.073 1.208,4.375 0.656,0.302 10 false RR+ 2.365,3.979 2.781,4.177 0.417,0.198 10 false RR- 2.427,1.708 3.01,1.99 0.583,0.281 10 false RL- 0.104,0.073 0.344,0.333 0.24,0.26 10 false *a
*A Rear Speed Sensor LH
*B Rear Speed Sensor RH
*a Component without harness connected
(Rear Speed Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance Rear Speed Sensor LH:
Tester Connection Specified Condition
1 (RL-) - 2 (RL+) 0.65 to 1.8 kΩ
1 (RL-) - Body ground 10 kΩ or higher
2 (RL+) - Body ground 10 kΩ or higher


Rear Speed Sensor RH:
Tester Connection Specified Condition
1 (RR-) - 2 (RR+) 0.65 to 1.8 kΩ
1 (RR-) - Body ground 10 kΩ or higher
8 (RR+) - Body ground 10 kΩ or higher


If the result is not as specified, replace the speed sensor.

HINT:

Check the speed sensor signal after replacing the speed sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE).