Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER
RM1880E _54 Brake _013227 BRAKE SYSTEM (OTHER) _0068566 BRAKE MASTER CYLINDER G

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure to tip of the master cylinder points downward when handling the master cylinder.

·

Make sure foreign matter does not attach to the clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.



PROCEDURE

Hide 1.CHECK AND ADJUST BRAKE BOOSTER PUSH ROD

HINT:

Adjust the booster push rod when the master cylinder is replaced with a new one. Adjustment is not necessary when the master cylinder is reinstalled and the booster is replaced with a new one.


a.
G102172
2.188,2.698 2.583,3.396 2.583,3.396 2.792,3.396 true 0.719,4.063 0.917,4.417 0.917,4.417 1.167,4.417 false 1.406,1.844 1.406,2.031 1.406,2.031 1.208,2.031 false 1.208,4.333 1.729,4.615 0.521,0.281 10 false SST 2.854,3.333 3.198,3.615 0.344,0.281 10 false *a 0.865,1.958 1.385,2.24 0.521,0.281 10 false SST
*a Apply Chalk


Set SST on the master cylinder and then lower the rod of SST until it just touches the piston.

SST
09737-00013  

HINT:

SST 09737-00012 can also be used.



b.

Apply chalk to the flat tip of the rod of SST. Turn SST upside down and measure the clearance between the brake booster push rod and SST.

Standard clearance:

0 mm (0 in.)


If there is clearance between the main body of SST and the shell of the brake booster, the push rod is protruding too far. If the chalk does not stick to the tip of the brake booster push rod, the push rod protrusion is insufficient.


c.
F040006
0.771,0.563 0.667,0.75 0.667,0.75 0.5,0.75 false 0.208,0.667 0.667,1 0.458,0.333 10 false SST

If the clearance is not as specified, adjust the length by holding the rod using SST and turning the tip of the rod using a 7 mm socket driver.

SST
09737-00020  

NOTICE:

Check the push rod clearance again after adjusting.