Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER
RM1880E _54 Brake _013227 BRAKE SYSTEM (OTHER) _0068566 BRAKE MASTER CYLINDER A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.


PROCEDURE

Hide 1.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 2.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

C111293
3.785,0.063 3.983,0.219 0.198,0.156 10 *B 0.114,0.035 0.305,0.185 0.191,0.149 10 *A
*A for LHD *B for RHD


a.

for Manual transmission:

Disconnect the clutch reservoir tube from the master cylinder.


b.

Disconnect the brake fluid level warning switch connector.


c.

Using a union nut wrench, disconnect the 5 brake lines from the master cylinder and 3-way.


d.

Remove the 2 nuts and bracket (with 3-way).

C111294
3.442,0.061 3.616,0.219 0.174,0.159 10 *B 0.125,0.061 0.335,0.215 0.21,0.154 10 *A
*A for LHD *B for RHD



e.

Pull out the master cylinder from the brake booster.


f.

Remove the O-ring from the master cylinder.