Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM1880E _54 Brake _013228 BRAKE (FRONT) _0068569 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 3.REMOVE FRONT FLEXIBLE HOSE

C121982

a.

Remove the union bolt and gasket.


b.

Disconnect the flexible hose from the disc brake cylinder.


Hide 4.REMOVE DISC BRAKE CYLINDER ASSEMBLY LH

C121983

a.

Remove the 2 bolts and disc brake cylinder assembly.


Hide 5.REMOVE FRONT DISC BRAKE PAD

a.

Remove the 2 front disc brake pads from the disc brake cylinder assembly.


Hide 6.REMOVE FRONT ANTI-SQUEAL SHIM KIT

a.

Remove the No. 1 and No. 2 anti-squeal shims from each pad.


Hide 7.DISCONNECT FRONT DISC BRAKE PAD SUPPORT PLATE

a.

Remove the 2 pad support plates from the brake cylinder mounting.


Hide 8.REMOVE FRONT DISC BRAKE CYLINDER MOUNTING LH

a.
C111362

Remove the 2 bolt and cylinder mounting.


Hide 9.REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN

a.
C121984

Remove the 2 front disc brake cylinder slide pins (upper and lower) from the mounting.


b.
C121985
2.094,1.052 2.281,1.052 false 2.281,1.052 2.281,1.375 false 1.177,1.438 1.177,1.781 false 1.406,1.042 1.281,0.594 1.281,0.594 1.083,0.594 false 1.083,1.813 1.406,2.083 0.323,0.271 10 false *1 2.188,1.406 2.51,1.688 0.323,0.281 10 false *2 0.896,0.51 1.25,0.781 0.354,0.271 10 false *3
*1 Cylinder Slide Bush
*2 Cylinder Slide Pin (Lower)
*3 Protective Tape


Using a screwdriver, remove the slide bush from the pin (lower).

NOTICE:

Be careful not to damage the pin.



Hide 10.REMOVE FRONT DISC BRAKE BUSH DUST BOOT

a.
C121986

Remove the 2 boots from the mounting.


Hide 11.REMOVE FRONT DISC

a.
C111383
2.135,1.115 2.135,0.188 2.135,0.188 1.115,0.188 true 2.115,1.26 1.948,1.26 1.948,1.26 1.948,0.188 true 0.906,0.104 1.083,0.271 0.177,0.167 10 false *1
*1 Matchmark


Put matchmarks on the disc and axle hub.


b.

Remove the disc.