Use the same procedure for the RH and LH sides.
The procedures listed below is for the LH side.
1.REMOVE CYLINDER BOOT
| *1 | Protective Tape |
Using a screwdriver, pry out the cylinder boot.
Tape the screwdriver tip before use.
Be careful not to damage the brake piston and cylinder.
2.REMOVE FRONT DISC BRAKE PISTON
| *a | 170 mm (6.70 in.) |
| *b | 50 mm (1.97 in.) |
| *c | 30 mm (1.18 in.) |
Prepare a wooden block to hold the pistons.
Place the wooden block between the piston and cylinder.
Use compressed air to remove the piston from the cylinder.
Do not place your fingers in front of the piston when using compressed air.
Be careful not to spatter the brake fluid.
3.REMOVE PISTON SEAL
| *1 | Protective Tape |
Using a screwdriver, pry out the seal from the cylinder.
Tape the screwdriver tip before use.
Be careful not to damage the inner cylinder and cylinder groove.
4.REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP
5.REMOVE FRONT DISC BRAKE BLEEDER PLUG
Remove the bleeder plug from the cylinder.