Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM1880E _54 Brake _013228 BRAKE (FRONT) _0068569 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.TEMPORARILY INSTALL FRONT DISC BRAKE BLEEDER PLUG

a.

Temporarily install the bleeder plug to the disc brake cylinder.

HINT:

The bleeder plug will be tightened to the torque specification in the Bleed Brake Line procedure.



Hide 2.INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP

Hide 3.INSTALL PISTON SEAL

a.

Apply lithium soap base glycol grease to a new seal.


b.

Install the seal to the cylinder.


Hide 4.INSTALL FRONT DISC BRAKE PISTON

a.
C191865
0.795,2.915 0.948,3.064 0.153,0.149 10 *1
*1 Lithium soap base glycol grease


Apply a light coat of lithium soap base glycol grease to the entire inner and outer circumference of a new piston seal.


b.

Install the piston seal to the disc brake cylinder.

NOTICE:

Make sure the piston seal is securely installed to the groove of the disc brake cylinder.



Hide 5.INSTALL FRONT DISC BRAKE PISTON

a.
C239760
0.688,2.927 1,3.177 0.313,0.25 10 false *1
*1 Lithium soap base glycol grease


Apply a light coat of lithium soap base glycol grease to the inner and outer circumference of a new cylinder boot, and the entire circumference of the top and bottom of the outer edge as shown in the illustration.


b.

Apply a light coat of lithium soap base glycol grease to the entire outer circumference of the front disc brake piston where it contacts the cylinder boot and front disc brake cylinder.


c.

Install the cylinder boot to the front disc brake piston.


d.

Install the front disc brake piston to the front disc brake cylinder.

NOTICE:

Do not forcibly install the disc brake piston to the disc brake cylinder.



Hide 6.INSTALL CYLINDER BOOT

a.
C122015
0.813,1.792 0.813,2.552 true 1.052,1.01 1.385,0.531 1.385,0.531 1.552,0.531 true 0.479,1.74 0.302,2.021 0.302,2.021 0.302,2.177 true 2.25,2.177 2.469,2.719 2.469,2.719 2.469,2.854 true 0.729,2.604 1,2.844 0.271,0.24 10 false *3 1.604,0.479 1.948,0.75 0.344,0.271 10 false *1 2.323,2.885 2.688,3.146 0.365,0.26 10 false SST 0.229,2.219 0.531,2.469 0.302,0.25 10 false *2
*1 Piston
*2 Cylinder
*3 cylinder Boot


Using SST and a hammer, tap in the cylinder boot to the disc brake cylinder.

SST
09550-60010  

NOTICE:
·

Do not damage the cylinder boot.

·

Install the boot securely to the grooves of the cylinder and piston.