Home › Brake › BRAKE (REAR) › REAR BRAKE
RM1880E _54 Brake _013229 BRAKE (REAR) _0068571 REAR BRAKE A

BRAKE (REAR)  REAR BRAKE  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.DISCONNECT REAR BRAKE SHOE RETURN SPRING

C238087

a.

Disconnect the rear brake shoe return spring from the front brake shoe and rear brake shoe.

NOTICE:

Be careful not to damage the wheel cylinder boot.



Hide 2.DISCONNECT SHOE TENSION SPRING

a.
C236969

Disconnect the shoe tension spring from the front brake shoe and rear brake shoe.


Hide 3.REMOVE FRONT BRAKE SHOE

C111397
1.344,1.104 0.479,1.104 0.479,1.104 0.479,1.542 true 0.354,1.573 0.698,1.781 0.344,0.208 10 false SST

a.

Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and front brake shoe.

SST
09718-00011  


Hide 4.REMOVE PARKING BRAKE SHOE STRUT SET LH

a.

Remove the parking brake shoe strut set from the rear brake shoe.

NOTICE:

Do not disassemble the strut set, and be careful not to damage or bend any of the components.



Hide 5.REMOVE REAR BRAKE SHOE

a.
C111398
1.927,1.167 2.115,1.167 2.115,1.167 2.115,0.781 false 2.115,0.781 2.448,0.781 false 2.5,0.698 2.813,0.854 0.313,0.156 10 SST

Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and rear brake shoe.

SST
09718-00011  


b.

Using needle-nose pliers, remove the adjust lever tension spring from the automatic adjust lever. Then remove the shoe.


c.
C236973

Using needle-nose pliers, disconnect the No. 3 parking brake cable from the parking brake shoe lever.


Hide 6.REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER LH

a.
C111481

Using a screwdriver, remove the E-ring and rear brake automatic adjust lever.


Hide 7.REMOVE REAR BRAKE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY

C236965

a.

Remove the C-washer and rear brake parking brake shoe lever.


Hide 8.REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY LH

a.
C111485

Using a union nut wrench, disconnect the brake line.


b.

Remove the 2 bolts and cylinder.


Hide 9.REMOVE REAR WHEEL BRAKE CYLINDER CUP

a.

Remove the 2 cylinder boots from the cylinder.


b.

Remove the 2 pistons and compression spring.


c.

Remove the 2 cups from each piston.


Hide 10.REMOVE REAR BRAKE DRUM BLEEDER PLUG CAP

Hide 11.REMOVE REAR BRAKE DRUM BLEEDER PLUG

a.

Remove the rear brake drum bleeder plug from the rear wheel brake cylinder.