When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
1.SECURE VANE PUMP ASSEMBLY
Using SST, secure the vane pump between aluminum plates in a vise, as shown in the illustration.
2.REMOVE FLOW CONTROL VALVE
Using a 27 mm socket wrench, remove the pressure port union from the front housing.
Using a screwdriver, remove the O-ring from the pressure port union.
Remove the flow control valve from the front housing.
Remove the compression spring from the front housing.
3.REMOVE POWER STEERING OIL PRESSURE SWITCH
Remove the oil pressure switch from the front housing.
Remove the O-ring from the oil pressure switch.
4.REMOVE REAR HOUSING
Remove the 4 bolts and rear housing from the front housing.
Remove the O-ring from the rear housing.
5.REMOVE SHAFT WITH PULLEY
Using a screwdriver, remove the shaft snap ring from the shaft with pulley.
Remove the shaft with pulley from the rear housing.
6.REMOVE VANE PUMP ROTOR
Remove the 10 vane pump plates from the vane pump rotor.
Be careful not to drop the vane pump plates.
Remove the vane pump rotor from the front housing.
7.REMOVE VANE PUMP CAM RING
8.REMOVE FRONT VANE PUMP SIDE PLATE
Remove the front vane pump side plate from the front housing.
Remove the No. 1 O-ring from the side plate.
Remove the No. 2 O-ring from the front housing.
9.REMOVE VANE PUMP HOUSING OIL SEAL
Using a screwdriver, pry out the oil seal.
Tape the screwdriver tip before use.