Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM1880E _55 Steering _013232 STEERING COLUMN _0068579 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  REASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 1.INSTALL STEERING MAIN SHAFT ASSEMBLY

a.
G102181

Using a snap ring expander, install a new inner steering main shaft snap ring to the steering main shaft.


b.

Install the steering main shaft to the steering column tube.


c.
G034355

Secure the steering column tube with a vise.


d.

Using a snap ring expander, install a new outer steering main shaft snap ring.


Hide 2.INSTALL STEERING MAIN SHAFT BEARING

a.
C241393
1.781,1.875 1.479,1.458 1.479,1.458 1.479,0.438 false 1.479,0.438 1.625,0.438 false 1.688,0.323 2.271,0.635 0.583,0.313 10 false SST

Using SST and a hammer, tap in the bearing until it is flush with the edge of the steering column tube.

SST
09608-06041  


Hide 3.INSTALL KEY INTERLOCK SOLENOID (for Automatic Transmission)

a.
G034357

Install the solenoid to the steering column upper bracket with the 2 screws.


Hide 4.INSTALL IGNITION SWITCH ASSEMBLY

a.
A301807

Attach the 2 claws to install the switch to the steering column upper bracket.


Hide 5.INSTALL UNLOCK WARNING SWITCH ASSEMBLY

a.
G102182

Attach the 2 claws to install the switch to the steering column upper bracket.


Hide 6.INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY

a.

Make sure that the lock cylinder is in the ACC position.


b.

Install the ignition switch lock cylinder.


Hide 7.INSPECT STEERING LOCK OPERATION

a.

Check that the steering lock mechanism is activated when the key is removed.


b.

Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.

If there is any abnormality, replace the ignition switch lock cylinder assembly.


Hide 8.INSTALL STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY

a.
G034356

Install the steering column upper bracket and steering column upper clamp with 2 new tapered-head bolts.


b.

Tighten the 2 tapered-head bolts until the bolt heads break off.


Hide 9.INSTALL TRANSPONDER KEY AMPLIFIER

a.
G034429

Align the amplifier with the upper bracket.


b.

Push on the amplifier to install it to the upper bracket.

NOTICE:

Do not apply excessive force to the amplifier as it may be damaged.



Hide 10.INSTALL STEERING SLIDING WITH COUPLING YOKE SUB-ASSEMBLY

a.
G034345
1.51,0.99 1.396,0.167 1.396,0.167 1.313,0.948 true 1.396,0.167 1.24,0.167 false 1.052,0.031 3.323,0.385 2.271,0.354 10 false *1
*1 Matchmark


Align the matchmarks on the yoke and steering main shaft.


b.

Install the steering yoke with the bolt.

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)