Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM1880E _55 Steering _013233 STEERING GEAR / LINKAGE _0068583 STEERING GEAR G

STEERING GEAR / LINKAGE  STEERING GEAR  INSPECTION  


PROCEDURE

Hide 1.INSPECT TIE ROD END SUB-ASSEMBLY

a.
ZK08184

Move the ball joint stud back and forth 5 times as shown in the illustration, before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.

Standard turning torque:

0.5 to 3.5 N*m (6 to 35 kgf*cm, 5 to 30 in.*lbf)



Hide 2.INSPECT STEERING LINK ASSEMBLY

a.
C212408
1.125,0.125 1.375,0.25 1.375,0.25 1.49,0.25 false 1.563,0.156 1.979,0.406 0.417,0.25 10 false SST

Using SST, check that the rack boot stretches smoothly when the control valve shaft is being rotated.

SST
09616-00011