1.INSPECT FRONT NO. 1 SPEAKER ASSEMBLY
| *a | Component without harness connected
(Front No. 1 Speaker Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Always | 4 Ω |
If the result is not as specified, replace the front No. 1 speaker assembly.
2.INSPECT FRONT NO. 2 SPEAKER ASSEMBLY
| *a | Component without harness connected
(Front No. 2 Speaker Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Always | Below 1 Ω |
| 3 - 4 | Always | Below 1 Ω |
| 1 - Body ground | Always | 10 kΩ or higher |
| 3 - Body ground | Always | 10 kΩ or higher |
If the result is not as specified, replace the front No. 2 speaker assembly.