Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type)
RM1880E _56 Audio / Visual / Telematics _013234 AUDIO / VIDEO _0068594 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Parking Brake Switch Circuit  


DESCRIPTION

This circuit is from the parking brake switch assembly to the radio and display receiver assembly.

WIRING DIAGRAM

C240177
5.292,2.833 6.563,3.365 1.271,0.531 10 false Navigation Receiver Assembly 2.979,2.219 4.302,2.76 1.323,0.542 10 false Parking Brake Switch Assembly 2.979,2.031 3.5,2.24 0.521,0.208 10 false K6 5.292,2.635 5.719,2.792 0.427,0.156 10 false G2 5.313,1.49 5.531,1.719 0.219,0.229 10 false 6 3.969,1.49 4.177,1.656 0.208,0.167 10 false 1 5.594,1.604 6.115,1.938 0.521,0.333 10 false PKB

PROCEDURE

1.INSPECT PARKING BRAKE SWITCH ASSEMBLY
a.

Remove the parking brake switch assembly.

Click hereBrake>PARKING BRAKE>PARKING BRAKE SWITCH>REMOVAL


b.
C217121
3.146,1.823 3.302,2.021 0.156,0.198 10 false .
V100135

On
V100136

Off


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
Switch connector - Switch body On (Shaft is not pressed) Below 1 Ω
Off (Shaft is pressed) 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - PARKING BRAKE SWITCH)

NG

REPLACE PARKING BRAKE SWITCH ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - PARKING BRAKE SWITCH)
a.

Disconnect the G2 radio and display receiver assembly connector.


b.

Disconnect the K6 parking brake switch assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G2-6 (PKB) - K6-1 Always Below 1 Ω
G2-6 (PKB) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR