Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type)
RM1880E _56 Audio / Visual / Telematics _013234 AUDIO / VIDEO _0068594 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) D

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  DTC CHECK / CLEAR  


START DIAGNOSTIC MODE


HINT:
·

Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be shown exactly the same as on the actual vehicle.

·

If the system cannot enter the diagnostic mode, replace the radio and display receiver assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>SYSTEM DESCRIPTION).



a.

Start the engine.


b.
C240173
0.1,0.074 0.289,0.249 0.189,0.175 10 *a
*a Example


While pressing and holding the "AUDIO" switch, operate the light control switch: off → turn on → turn off → turn on → turn off → turn on → turn off.


c.
E222227

Diagnostic mode starts and the "Service Menu" screen is displayed.



FINISH DIAGNOSTIC MODE


a.

There are 2 methods to end diagnostic mode. Use one of them.

i.

Turn the ignition switch off.


ii.

Press and hold the "AUDIO" switch for 3 seconds.




FAILURE DIAGNOSIS


a.
E222228

Touch the "Failure Diagnosis" button on the "Service Menu" screen.


b.
E222229

The "Failure Diagnosis" screen is displayed.



SYSTEM CHECK


a.
E222230

Touch the "System Check" button on the "Failure Diagnosis" screen.


b.
E222231

The "System Check Mode" screen is displayed.



CHECK DTC (CHECK USING SYSTEM CHECK MODE SCREEN)


a.

Read the system check result.


b.
E222234
1.021,1.063 0.875,1.313 false 0.75,1.281 1.031,1.51 0.281,0.229 10 false *a
*a Check Result


If the check result is "DETAIL", touch the displayed check result.


c.
E222238
0.802,1.073 1.031,1.802 1.031,1.802 1.302,1.073 true 0.969,1.865 2.063,2.031 1.094,0.167 10 false *a
*a Diagnostic Code


View the results on the "Unit Check Mode" screen and record them.


d.

When proceeding to view the results of another device, touch the "Back" button to return to the "System Check Mode" screen.

HINT:

To check the other items, repeat this procedure from the first step.




DTC CLEAR/RECHECK (CLEAR USING SYSTEM CHECK MODE SCREEN)


a.

Clear DTC

i.
E222240

Touch the "Code CLR" button for 3 seconds.


ii.

Confirm that the check results are cleared.

HINT:
·

To clear the DTC for a specific device, clear the DTC using the "Unit Check Mode" screen.

·

When clearing a DTC using the "Unit Check Mode" screen, touch the "Code CLR" button for 3 seconds.





b.

Recheck

i.
E222241

Touch the "Recheck" button.


ii.
E222242

Confirm that all check results are "OK" when the check results are displayed. If a result other than "OK" is displayed, troubleshoot again.

HINT:

When a DTC is cleared using the "Unit Check Mode" screen, touch the "Back" button to return to the "System Check Mode" screen and perform this operation.