Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH
RM1880E _56 Audio / Visual / Telematics _013235 PARK ASSIST / MONITORING _0068597 CLEARANCE SONAR MAIN SWITCH G

PARK ASSIST / MONITORING  CLEARANCE SONAR MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY

a.
E225062
0.969,1.698 0.969,1.375 0.969,1.375 1.156,1.271 true 1.479,1.688 1.479,1.365 1.479,1.365 1.563,1.292 true 1.896,1.698 1.896,1.375 1.896,1.375 1.844,1.292 true 2.177,1.677 2.177,1.354 2.177,1.354 2.063,1.271 true 2.635,1.698 2.635,1.375 2.635,1.375 2.271,1.271 true 2.115,1.781 2.521,2.042 0.406,0.26 10 false ILL- 2.552,1.781 3.021,2.031 0.469,0.25 10 false ILL+ 1.854,1.771 2.219,2.01 0.365,0.24 10 false IG 1.344,1.76 1.771,2 0.427,0.24 10 false ECU 0.938,1.76 1.229,1.99 0.292,0.229 10 false E 0.052,0 0.292,0.198 0.24,0.198 10 false *a
*a Component without harness connected
(Back Sonar or Clearance Sonar Switch Assembly)


Resistance measurement of the back sonar or clearance sonar switch assembly.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (IG) - 4 (ECU) Back sonar or clearance sonar switch assembly pushed in Below 1 Ω
Back sonar or clearance sonar switch assembly not pushed 10 kΩ or higher


If the result is not as specified, replace the back sonar or clearance sonar switch assembly.



b.

Inspect the illumination light.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (ILL+) - 2 (ILL-) Always Below 1 Ω
3 (IG) - 6 (E) Back sonar or clearance sonar switch assembly pushed in Below 1 Ω
Back sonar or clearance sonar switch assembly not pushed 10 kΩ or higher


If the result is not as specified, replace the bulb, and perform the on-vehicle inspection described above to inspect the illumination light again.

If the result is not as specified even when the bulb is replaced, replace the back sonar or clearance sonar switch assembly.