Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM
RM1880E _56 Audio / Visual / Telematics _013235 PARK ASSIST / MONITORING _0068601 TOYOTA PARKING ASSIST-SENSOR SYSTEM U

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  TERMINALS OF ECU  


CHECK REAR CLEARANCE WARNING ECU ASSEMBLY


E149991
3.427,0.094 3.823,0.302 0.396,0.208 3.563,0.125 3.865,0.333 0.302,0.208 10 false T1

a.

Measure the resistance, voltage and waveform according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
T1-3 (SPD) - Body ground V-R - Body ground Vehicle speed signal Ignition switch ON, back sonar or clearance sonar switch on, vehicle speed signal input Pulse generation
(Frequency changes according to vehicle speed)
T1-6 (SOR) - T1-22 (E2) P - L No. 1 ultrasonic sensor communication signal Ignition switch ON, back sonar or clearance sonar switch on, sensor detects obstacle Pulse generation
(See waveform 1)
T1-10 (IG) - Body ground L-R - Body ground IG power source circuit Ignition switch ON, back sonar or clearance sonar switch on 11 to 14 V
Ignition switch ON, back sonar or clearance sonar switch off Below 1 V
T1-12 (BBZ) - Body ground P-G - Body ground No. 1 clearance warning buzzer signal Ignition switch ON, back sonar or clearance sonar switch on, shift lever in reverse position and sensor is in detecting state (buzzer sounding) Pulse generation
(See waveform 2)
Buzzer not sounding Below 1 V
T1-13 (RL) - T1-21 (E) R-W - W-B Reverse position signal Ignition switch ON, shift lever moved to R 7 V or higher
Ignition switch ON, shift lever moved to any position except R Below 1 V
T1-21 (E) - Body ground W-B - Body ground Ground Always Below 1 Ω
T1-22 (E2) - Body ground L - Body ground No. 1 ultrasonic sensor ground Always Below 1 V
T1-24 (BOR) - T1-22 (E2) BR - L No. 1 ultrasonic sensor power source circuit Ignition switch ON, back sonar or clearance sonar switch on 7.2 to 8.8 V
Ignition switch off Below 1 V

i.
E159890
0.094,1.583 0.469,1.958 0.375,0.375 10 false GND

Using an oscilloscope, check waveform 1.

Measurement Condition
Item Content
Terminal No. (Symbol) T1-6 (SOR) - T1-22 (E2)
Tool Setting 2 V/DIV., 1 msec./DIV.
Condition Ignition switch ON, back sonar or clearance sonar switch on, sensor detects obstacle


ii.
E051095

Using an oscilloscope, check waveform 2.

Measurement Condition
Item Content
Terminal No. (Symbol) T1-12 (BBZ) - Body ground
Tool Setting 5 V/DIV., 1 msec./DIV.
Condition Ignition switch ON, back sonar or clearance sonar switch on, shift lever in reverse position and sensor is in detecting state (buzzer sounding)

NOTICE:

The waveform's amplitude varies depending on the volume setting.