Home › Vehicle Interior › DOOR LOCK › KEY REMINDER WARNING SYSTEM
RM1880E _58 Vehicle Interior _013237 DOOR LOCK _0068606 KEY REMINDER WARNING SYSTEM U

DOOR LOCK  KEY REMINDER WARNING SYSTEM  TERMINALS OF ECU  


CHECK COMBINATION METER ASSEMBLY


B276909
1.594,0.135 2.01,0.385 0.417,0.25 1.667,0.177 2.021,0.396 0.354,0.219 10 false G19

a.

Disconnect the G19 combination meter assembly connector.


b.

Measure the resistance and voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
G19-1 (B) - Body ground R - Body ground Battery power supply Always 11 to 14 V
G19-21 (IG+) - Body ground B-O - Body ground IG2 input signal Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
G19-22 (EP) - Body ground Y - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.



c.

Reconnect the G19 combination meter assembly connector.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
G19-10 (KSW) - Body ground G-Y - Body ground Unlock warning switch input signal No key in ignition key cylinder Below 1 V
Ignition switch off, key in ignition key cylinder 11 to 14 V
G19-16 (DCTY) - Body ground R-B - Body ground Driver side door input signal Driver side door closed Below 1 V
Driver side door open 11 to 14 V

If the result is not as specified, the combination meter assembly may be malfunctioning.