1.INSPECT REAR DOOR LOCK ASSEMBLY LH
Apply battery voltage to the door lock and check operation of the door lock motor.
| *a | Lock | *b | Unlock |
| *c | Component without harness connected
(Rear Door Lock Assembly LH) |
- | - |
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 4 (L)
Battery negative (-) → Terminal 1 (UL) |
Lock |
| Battery positive (+) → Terminal 1 (UL)
Battery negative (-) → Terminal 4 (L) |
Unlock |
If the result is not as specified, replace the rear door lock assembly LH.
2.INSPECT REAR DOOR LOCK ASSEMBLY RH
Apply battery voltage to the door lock and check operation of the door lock motor.
| *a | Unlock | *b | Lock |
| *c | Component without harness connected
(Rear Door Lock Assembly RH) |
- | - |
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 4 (L)
Battery negative (-) → Terminal 1 (UL) |
Lock |
| Battery positive (+) → Terminal 1 (UL)
Battery negative (-) → Terminal 4 (L) |
Unlock |
If the result is not as specified, replace the rear door lock assembly RH.