Home › Vehicle Interior › DOOR LOCK › BACK DOOR LOCK
RM1880E _58 Vehicle Interior _013237 DOOR LOCK _0068613 BACK DOOR LOCK G

DOOR LOCK  BACK DOOR LOCK  INSPECTION  


PROCEDURE

Hide 1.INSPECT BACK DOOR LOCK ASSEMBLY

a.

Check the operation of the door lock motor.

B277962
6.125,1.76 6.302,2.104 true 5.906,1.76 5.76,2.104 true 0.688,1.021 0.885,1.198 0.198,0.177 10 *a 1.01,1.927 1.208,2.104 0.198,0.177 10 *b 5.521,1.146 5.75,1.344 0.229,0.198 10 *c 5.625,2.104 6.094,2.323 0.469,0.219 10 ACT+ 6.156,2.104 6.563,2.302 0.406,0.198 10 ACT-
*a Lock *b Unlock
*c Component without harness connected
(Back Door Lock Assembly)
- -


i.

Apply battery voltage to the door lock motor connector and check the operation of the door lock motor.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 4 (ACT+)
Battery negative (-) → Terminal 3 (ACT-)
Lock
Battery positive (+) → Terminal 3 (ACT-)
Battery negative (-) → Terminal 4 (ACT+)
Unlock


If the result is not as specified, replace the back door lock assembly.



b.

Check operation of the door courtesy switch.

i.

Measure the resistance according to the value(s) in the table below.

B277963
4.333,0.594 4.573,0.719 true 4.146,0.594 3.938,0.698 true 3.906,0.156 4.146,0.344 0.24,0.188 10 *a 2.458,1.229 2.698,1.417 0.24,0.188 10 *b 2.698,2.333 2.938,2.521 0.24,0.188 10 *c 3.917,2.333 4.156,2.521 0.24,0.188 10 *d 5.125,2.333 5.365,2.521 0.24,0.188 10 *e 6.375,2.333 6.615,2.521 0.24,0.188 10 *f 4.563,0.656 4.771,0.938 0.208,0.281 12 - 3.875,0.677 4.063,0.875 0.188,0.198 12 +
*a Component without harness connected
(Back Door Lock Assembly)
*b Latch Condition
*c Open-latch *d Half-latch
*e Full-latch *f Over-latch


Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (-) - 2 (+) Open-latch (ON) Below 1 Ω
Half-latch (ON) Below 1 Ω
Full-latch (OFF) 10 kΩ or higher
Over-latch (OFF) 10 kΩ or higher


If the result is not as specified, replace the back door lock assembly.