The theft warning ECU assembly detects the condition of the front door courtesy light switch assembly (for Front Passenger Side).
Remove the front door courtesy light switch assembly LH.
Click hereVehicle Interior>LIGHTING (INT)>FRONT DOOR COURTESY SWITCH>REMOVAL
| *a | Not pushed (ON) |
| *b | Pushed (OFF) |
| *c | Body ground |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - Body ground | Not pushed (ON) | Below 1 Ω |
| Pushed (OFF) | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K4 front door courtesy light switch assembly LH connector.
Disconnect the G124 theft warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K4-1 - G124-7 (CTY) | Always | Below 1 Ω |
| K4-1 or G124-7 (CTY) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>PROBLEM SYMPTOMS TABLE
NG