Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM
RM1880E _58 Vehicle Interior _013238 THEFT DETERRENT / KEYLESS ENTRY _0068616 THEFT DETERRENT SYSTEM J

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  Rear Door Courtesy Switch LH Circuit  


DESCRIPTION

The Theft warning ECU assembly detects the condition of the rear door courtesy light switch assembly LH.

WIRING DIAGRAM

B276107
5.648,0.745 5.959,0.918 0.31,0.173 10 CTY 4.975,1.521 5.408,1.694 0.433,0.173 10 G124 4.975,1.701 6.856,1.874 1.881,0.173 10 Theft Warning ECU Assembly 1.978,1.629 2.288,1.802 0.31,0.173 10 K12 1.978,1.808 3.665,2.169 1.687,0.361 10 Rear Door Courtesy Light Switch Assembly LH 5.447,0.665 5.569,0.838 0.122,0.173 10 7 1.739,1.408 1.861,1.581 0.122,0.173 10 1

PROCEDURE

1.INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY LH
a.

Remove the rear door courtesy light switch assembly LH.

Click hereVehicle Interior>LIGHTING (INT)>REAR DOOR COURTESY SWITCH>REMOVAL


b.
B276106
0.865,1.375 0.625,1.771 0.625,1.771 0.396,1.771 true 0.948,0.167 1.25,0.417 0.302,0.25 10 *a 0.948,0.667 1.167,0.885 0.219,0.219 10 *b 0.177,1.677 0.427,1.875 0.25,0.198 10 *c
*a Not pushed (ON)
*b Pushed (OFF)
*c Body ground


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - Body ground Not pushed (ON) Below 1 Ω
Pushed (OFF) 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH LH - THEFT WARNING ECU)

NG

REPLACE REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY LH

2.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH LH - THEFT WARNING ECU)
a.

Disconnect the K12 rear door courtesy light switch assembly LH connector.


b.

Disconnect the G124 theft warning ECU assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K12-1 - G124-7 (CTY) Always Below 1 Ω
K12-1 or G124-7 (CTY) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR