Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE HOOD COURTESY SWITCH
RM1880E _58 Vehicle Interior _013238 THEFT DETERRENT / KEYLESS ENTRY _0068617 ENGINE HOOD COURTESY SWITCH A

THEFT DETERRENT / KEYLESS ENTRY  ENGINE HOOD COURTESY SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 1.INSTALL HOOD LOCK ASSEMBLY

a.
E225116

Apply MP grease to the sliding areas of the lock.


b.

Connect the hood lock control cable assembly.


c.

Connect the connector.


d.
E226392

Move the hood lock the direction of the arrows in the illustration to temporarily install it.


e.

Install the hood lock assembly with the 3 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)