1.INSPECT HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH)
| *a | Component without harness connected
(Hood Lock Assembly) |
| *b | Unlock position |
| *c | Lock position |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Unlock position | 10 kΩ or higher |
| 1 - 2 | Lock position | Below 1 Ω |
If the result is not as specified, replace the hood lock assembly.