Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SECURITY INDICATOR LIGHT ASSEMBLY
RM1880E _58 Vehicle Interior _013238 THEFT DETERRENT / KEYLESS ENTRY _0068620 SECURITY INDICATOR LIGHT ASSEMBLY G

THEFT DETERRENT / KEYLESS ENTRY  SECURITY INDICATOR LIGHT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 1.INSPECT SECURITY INDICATOR LIGHT ASSEMBLY

B119749
2.813,0.875 2.813,0.458 2.813,0.458 2.969,0.458 true 2.823,1.24 2.823,1.656 2.823,1.656 2.979,1.656 true 1.677,0.063 1.885,0.24 0.208,0.177 10 false *a 3,1.573 3.125,1.719 0.125,0.146 10 false E 2.99,0.375 3.188,0.51 0.198,0.135 10 false LP
*a Component without harness connected
(Security Indicator Light Assembly)


a.

Apply battery voltage between the terminals of the indicator, and check the illumination of the security indicator light assembly.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 2 (LP)
Battery negative (-) → Terminal 1 (E)
Illuminates


NOTICE:
·

If the positive (+) lead and the negative (-) lead are incorrectly connected, the security indicator light will not illuminate.

·

If the voltage is too low, the security indicator light will not illuminate.



If the result is not as specified, replace the security indicator light assembly.