Home › Vehicle Interior › LIGHTING (INT) › PERSONAL LIGHT
RM1880E _58 Vehicle Interior _013239 LIGHTING (INT) _0068623 PERSONAL LIGHT G

LIGHTING (INT)  PERSONAL LIGHT  INSPECTION  


PROCEDURE

Hide 1.INSPECT MAP LIGHT ASSEMBLY (w/ Courtesy Light Switch)

a.
E224853
2.385,1.208 2.042,1.208 false 0.99,1.104 1.323,1.104 false 1.615,1.271 1.615,1.615 false 0.229,0.052 0.573,0.313 0.344,0.26 10 false *a 2.438,1.115 2.688,1.344 0.25,0.229 10 false B 0.656,1 1.01,1.208 0.354,0.208 10 false CTY 1.573,1.667 1.813,1.896 0.24,0.229 10 false E
*a Component without harness connected
(Map Light Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
7 (B) - 10 (E) Spot light switch off 10 kΩ or higher
Spot light switch on Below 1 Ω
7 (B) - 6 (CTY) Not door position 10 kΩ or higher
Door position Below 1 Ω


If the result is not as specified, replace the map light assembly.


Hide 2.INSPECT MAP LIGHT ASSEMBLY (w/o Courtesy Light Switch)

a.
E224853
2.365,1.208 2.042,1.208 true 1.625,1.271 1.625,1.625 true 0.229,0.052 0.51,0.229 0.281,0.177 10 false *a 2.406,1.125 2.74,1.354 0.333,0.229 10 false B 1.594,1.677 1.896,1.927 0.302,0.25 10 false E
*a Component without harness connected
(Map Light Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
7 (B) - 10 (E) Spot light switch off 10 kΩ or higher
Spot light switch on Below 1 Ω


If the result is not as specified, replace the map light assembly.