1.REMOVE MAP LIGHT ASSEMBLY
Remove the 2 screws.
Detach the claw and 2 guides and remove the map light assembly.
Disconnect the connector.
2.REMOVE NO. 1 MAP LIGHT LENS
| *1 | Protective Tape |
Using a screwdriver wrapped with protective tape, detach the claw and remove the No. 1 map light lens.
Protective tape the screwdriver tip before use.
3.REMOVE NO. 2 MAP LIGHT LENS
Use the same procedures described for the No. 1 map light lens.
4.REMOVE MAP LIGHT BULB
Remove the 2 map light bulbs from the map light assembly.