Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM1880E _58 Vehicle Interior _013240 METER / GAUGE / DISPLAY _0068630 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Tachometer Malfunction  


DESCRIPTION

In this circuit, the combination meter assembly receives engine speed signals from the ECM. The meter CPU displays the engine speed, which is calculated based on the data received from the ECM.

WIRING DIAGRAM

E273791
1.344,1.469 1.583,1.719 0.24,0.25 10 false 1 0.208,2.563 0.719,2.833 0.51,0.271 10 false G88 0.542,2.75 1.052,3.021 0.51,0.271 10 false ECM 0.896,1.583 1.406,1.854 0.51,0.271 10 false TACH 5.74,1.479 5.979,1.729 0.24,0.25 10 false 7 5.979,1.563 6.219,1.813 0.24,0.25 10 false S 5.906,2.573 6.417,2.844 0.51,0.271 10 false G19 5.917,2.771 7.115,3.438 1.198,0.667 10 false Combination Meter Assembly

PROCEDURE

1.CHECK COMBINATION METER ASSEMBLY
a.

Disconnect the G19 combination meter assembly connector.


b.
E234304
1.521,0.333 1.938,0.583 0.417,0.25 1.031,0.448 1.25,0.448 1.25,0.448 1.25,1.198 true 0.177,0.167 0.49,0.365 0.313,0.198 10 false *a 0.865,0.396 1.083,0.625 0.219,0.229 10 false S 1.594,0.375 1.927,0.573 0.333,0.198 10 false G19 2.802,3.51 3.26,3.708 0.458,0.198 10 false GND
*a Front view of wire harness connector
(to Combination Meter Assembly)


Using an oscilloscope, check the signal waveform of the meter.

Measurement Condition:
Item Condition
Tester Connection G19-7 (S) - Body ground
Tool Setting 5 V/DIV., 10 msec./DIV.
Condition Engine idling


OK:

The waveform displayed is as shown in the illustration.


HINT:

As the engine speed increases, the wavelength shortens.



Result:
Proceed to
OK
NG



OK

REPLACE COMBINATION METER ASSEMBLY

NG

2.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)
2.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)
a.

Disconnect the G19 combination meter assembly connector.


b.

Disconnect the G88 ECM connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G19-7 (S) - G88-1 (TACH) Always Below 1 Ω
G19-7 or G88-1 (TACH) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR