Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY
RM1880E _58 Vehicle Interior _013243 SEAT _0068642 FRONT SEAT ASSEMBLY A

SEAT  FRONT SEAT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE INNER SEAT TRACK BRACKET COVER LH

a.

Lift up the seat track handle sub-assembly LH and move the seat to the foremost position.


b.
B278167

Using a moulding remover, detach the 2 claws and remove the inner seat track bracket cover LH.


Hide 2.REMOVE SEAT TRACK COVER LH

a.
B278168

Using a moulding remover, detach the 2 claws and remove the seat track cover LH.


Hide 3.REMOVE FRONT SEAT HEADREST ASSEMBLY

a.

Remove the front seat headrest assembly.


Hide 4.REMOVE FRONT SEAT ASSEMBLY

a.
B207784

Remove the 2 bolts.


b.

Lift up the seat track handle sub-assembly LH and move the seat to the rearmost position.


c.
B207785

Remove the 2 bolts.


d.

Lift up the seat track handle sub-assembly LH and move the seat to the center position. Also, operate the reclining adjuster release handle LH and move the seatback to the upright position.


e.

Disconnect the connector and detach the wire harness clamp from under the seat.


f.

Remove the front seat assembly from the vehicle.

NOTICE:

Be careful not to damage the vehicle body.