Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the RH side.
1.INSTALL REAR NO. 1 SEAT ASSEMBLY
Place the rear No. 1 seat assembly in the cabin.
Be careful not to damage the vehicle body.
Temporarily install the rear No. 1 seat assembly with the 4 bolts.
Operate the seat track adjusting handle and move the seat to the rearmost position.
Tighten the 2 bolts in the order shown in the illustration.
Operate the seat track adjusting handle and move the seat to the foremost position.
Tighten the 2 bolts in the order shown in the illustration.
2.INSTALL REAR OUTER SEAT TRACK BRACKET COVER RH
Attach the 3 claws to install the rear outer seat track bracket cover RH.
3.INSTALL REAR INNER SEAT TRACK BRACKET COVER RH
Attach the claw to install the rear inner seat track bracket cover RH.
4.INSTALL OUTER SEAT TRACK BRACKET COVER RH
Operate the seat track adjusting handle and move the seat to the rearmost position.
Attach the claw to install the outer seat track bracket cover RH.
Install the clip.
5.INSTALL INNER SEAT TRACK BRACKET COVER RH
Attach the 2 claws to install the inner seat track bracket cover RH.