Home › Vehicle Interior › SEAT › REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Tumble Seat Type RH Side)
RM1880E _58 Vehicle Interior _013243 SEAT _0068645 REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Tumble Seat Type RH Side) A

SEAT  REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Tumble Seat Type RH Side)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


PROCEDURE

Hide 1.INSTALL REAR NO. 1 SEAT ASSEMBLY RH

a.

Place the rear No. 1 seat assembly RH in the cabin.

NOTICE:

Be careful not to damage the vehicle body.



b.
B279377

Temporarily install the rear No. 1 seat assembly RH with the 2 nuts.


c.

Raise the rear No. 1 seat assembly RH.


d.
B277456

Temporarily install the 2 bolts.


e.

Operate the reclining remote control lever knob RH and tumble the rear No. 1 seat assembly RH.


f.
B283137
0.7,2.046 0.892,2.218 0.193,0.172 10 (1) 0.852,2.946 1.045,3.118 0.193,0.172 10 (2)

Tighten the 2 nuts in the order shown in the illustration.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


g.

Raise the rear No. 1 seat assembly.


h.
B283138
1.625,1.823 2.01,2.083 0.385,0.26 10 false (1) 1.031,1.302 1.385,1.563 0.354,0.26 10 false (2)

Tighten the 2 bolts in the order shown in the illustration.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


i.

Operate the reclining adjuster release handle and raise the seatback to the upright position.


Hide 2.INSTALL REAR SEAT CUSHION HINGE COVER LH

a.

Attach the guide and claw to install the rear seat hinge cover LH.


b.

Install the clip.


Hide 3.INSTALL REAR SEAT CUSHION HINGE COVER RH

HINT:

Use the same procedure described for the LH side.