Home › Vehicle Interior › SEAT › REAR NO. 2 SEAT ASSEMBLY
RM1880E _58 Vehicle Interior _013243 SEAT _0068646 REAR NO. 2 SEAT ASSEMBLY A

SEAT  REAR NO. 2 SEAT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the RH side.



PROCEDURE

Hide 1.INSTALL REAR SEAT LOCK STRIKER

a.

Install the 2 rear seat lock strikers with the 4 bolts.

HINT:

Use the same procedure for both rear seat lock strikers.


Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


b.
B277665

Attach the 2 hooks to install the floor carpet.


c.

Attach the 6 clips, 4 claws and 2 guides to install the back door scuff plate.


d.

Return the rear No. 2 seat assembly to the upright position.


Hide 2.INSTALL REAR NO. 2 SEAT ASSEMBLY

B276785

a.

Fully tilt the seatback forward.


b.

Place the rear No. 2 seat assembly onto the rear seat lock strikers.

NOTICE:

Be careful not to damage the vehicle body.



c.

Temporarily install the 2 bolts.


d.

Tighten the bolt on the rear side of the seat.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


e.

Tighten the bolt on the front side of the seat.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


f.

Fully attach the seat to the lock strikers.

HINT:

Confirm that the seat is firmly attached to the lock strikers.



Hide 3.INSTALL REAR SEAT REAR BRACKET COVER RH

B276783

a.

Attach the guide to install the rear seat rear bracket cover RH.


b.

Install the screw.


c.

Return the seatback to the upright position.


Hide 4.INSTALL REAR SEAT FRONT BRACKET COVER RH

B276781

a.

Attach the guide to install the rear seat front bracket cover RH.


b.

Install the screw.