Home › Vehicle Interior › SEAT › REAR NO. 2 SEAT ASSEMBLY
RM1880E _58 Vehicle Interior _013243 SEAT _0068646 REAR NO. 2 SEAT ASSEMBLY A

SEAT  REAR NO. 2 SEAT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the RH side.



PROCEDURE

Hide 1.REMOVE REAR SEAT FRONT BRACKET COVER RH

B276780

a.

Remove the screw.


b.

Pull the rear seat front bracket cover RH in the direction indicated by the arrow in the illustration to detach the guide and remove the rear seat front bracket cover RH.


Hide 2.REMOVE REAR SEAT REAR BRACKET COVER RH

B276782

a.

Fully tilt the seatback forward.


b.

Remove the screw.


c.

Pull the rear seat rear bracket cover RH in the direction indicated by the arrow in the illustration to detach the guide and remove the rear seat rear bracket cover RH.


Hide 3.REMOVE REAR NO. 2 SEAT ASSEMBLY

B276784

a.

Remove the 2 bolts.


b.

Unlock the seat legs by horizontally pulling the No. 2 seat reclining release handle sub-assembly, and then remove the rear No. 2 seat assembly.

NOTICE:

Be careful not to damage the vehicle body.



Hide 4.REMOVE REAR SEAT LOCK STRIKER

a.

Move the rear No. 2 seat assembly to the storage position.


b.
B279272

Detach the 6 clips, 4 claws and 2 guides and remove the back door scuff plate.


c.
B277664

Detach the 2 hooks and partially remove the floor carpet.


d.
B277666

Remove the 4 bolts and 2 rear seat lock strikers.

HINT:

Use the same procedure for both rear seat lock strikers.