Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR
RM1880E _58 Vehicle Interior _013244 SEAT BELT _0068649 OCCUPANT DETECTION SENSOR G

SEAT BELT  OCCUPANT DETECTION SENSOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT SEPARATE TYPE FRONT SEAT CUSHION PAD

B276075

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Seat belt is unfastened
More than 147 N (15 kgf, 33.0 lbf) is applied to occupant detection sensor
Below 100 Ω
1 - 2 Seat belt is fastened
More than 147 N (15 kgf, 33.0 lbf) is applied to occupant detection sensor
1 MΩ or higher


If the result is not as specified, replace the separate type front seat cushion pad.