Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)
RM1880E _58 Vehicle Interior _013245 HEATING / AIR CONDITIONING _0068660 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  IG Power Source Circuit  


DESCRIPTION

The main power source is supplied to the air conditioning amplifier assembly when the ignition switch is turned to on. The power source is used for operating the air conditioning amplifier assembly, servo motors, etc.

WIRING DIAGRAM

E227739
0.198,0.396 0.979,1.188 0.781,0.792 10 false from Ignition Switch 2.49,0.594 3.771,1.042 1.281,0.448 10 false ECU-IG&GAUGE 5.375,0.323 5.656,0.646 0.281,0.323 10 false 6 5.531,0.406 5.917,0.771 0.385,0.365 10 false IG+ 5.531,1.094 6.021,1.438 0.49,0.344 10 false GND 5.396,0.99 5.656,1.271 0.26,0.281 10 false 1 5.229,2.021 5.656,2.365 0.427,0.344 10 false G94 5.208,2.198 6.75,2.76 1.542,0.563 10 false Air Conditioning Amplifier Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY AND BODY GROUND)
E272047
0.656,1.167 1.073,1.417 0.417,0.25 0.885,1.823 1.302,1.406 true 2.729,1.792 2.406,1.354 true 0.135,0.094 0.448,0.385 0.313,0.292 10 false *a 0.74,1.208 1.094,1.5 0.354,0.292 10 false G94 0.573,1.771 0.927,2.063 0.354,0.292 10 false GND 2.75,1.792 3.104,2.083 0.354,0.292 10 false IG+
*a Front view of wire harness connector
(to Air Conditioning Amplifier Assembly)


a.

Disconnect the G94 air conditioning amplifier assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
G94-6 (IG+) - Body ground Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G94-1 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR