Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)
RM1880E _58 Vehicle Interior _013245 HEATING / AIR CONDITIONING _0068660 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) D

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  SYSTEM DESCRIPTION  


GENERAL


a.

The air conditioning system has the following features:

·

The air conditioning amplifier assembly is equipped with a self-diagnosis function. If there is a malfunction in the system, it stores DTCs in its memory and the air conditioning switch indicator blinks.

·

The air conditioning amplifier assembly receives the vehicle speed signal from the combination meter.

·

The recirculation damper servo sub-assembly, air mix damper servo sub-assembly and mode damper servo sub-assembly rely on their built-in pulse sensors to detect their respective motor rotation angles.

·

The servo motor rotation angle zero point calibration is necessary in the following situations: 1) the servo motor deviates from the calibrated position, 2) the air conditioning amplifier assembly backup power source is cut, or 3) the air conditioning amplifier assembly or servo motor is replaced.

For 1, when the ignition switch is turned off, zero point calibration of the air conditioning amplifier assembly is automatically performed. For 2 and 3, when the backup power source returns and the ignition switch is turned to ON, zero point calibration of the air conditioning amplifier assembly is automatically performed.

While zero point calibration is being performed, the following occurs: 1) the DEF indicator blinks at 1 second intervals, but the air conditioning amplifier assembly other outputs are disabled; and 2) the air conditioning system switches do not function.

·

When the front air conditioning is not operating, the rear cooler can only blow out air.




MODE POSITION AND DAMPER OPERATION


E225507
2.885,2.51 3.865,1.302 true 1.177,3.031 0.531,3.365 true 3.25,2.958 5.104,2.958 true 2.479,2.625 2.594,2.781 0.115,0.156 10 true E 2.479,0.76 2.75,0.938 0.271,0.177 10 false *4 1.938,2.021 2.188,2.229 0.25,0.208 10 false *b 0.958,2.021 1.208,2.229 0.25,0.208 10 false *a 1.021,4.219 1.271,4.406 0.25,0.188 10 false *5 0.333,3.313 0.615,3.552 0.281,0.24 10 false *1 2.51,4.479 2.74,4.656 0.229,0.177 10 false *7 4.104,4.219 4.396,4.427 0.292,0.208 10 false *6 5.063,4.479 5.302,4.708 0.24,0.229 10 false *7 6.125,4.229 6.406,4.417 0.281,0.188 10 false *5 5.167,2.844 5.438,3.052 0.271,0.208 10 false *3 3.917,1.177 4.219,1.385 0.302,0.208 10 false *2 1.125,2.354 1.313,2.531 0.188,0.177 10 false B 1.813,2.354 2.031,2.573 0.219,0.219 10 false A 3.042,2.823 3.188,3.01 0.146,0.188 10 true C 2.833,2.656 3.063,2.865 0.229,0.208 10 false D 2.74,1.792 2.865,1.948 0.125,0.156 10 true G 2.573,1.969 2.708,2.115 0.135,0.146 10 false F 2.927,1.781 3.083,1.938 0.156,0.156 10 false H 3.438,2.031 3.594,2.188 0.156,0.156 10 false I 3.594,2.167 3.76,2.333 0.167,0.167 10 false J 3.563,2.365 3.708,2.563 0.146,0.198 10 false K
*1 Blower with Fan Motor Sub-assembly *2 Heater Radiator Unit Sub-assembly
*3 No. 1 Evaporator Sub-assembly *4 Front Defroster
*5 Side Register *6 Center Register
*7 Front Footwell Register Duct - -
*a Fresh Air *b Recirculated Air


HINT:

This Illustration is damper operation image. The number and location of the dampers is different to the actual unit.


Control Damper Operation Position Damper Position Operation
Air Inlet Control Damper FRESH A Brings in fresh air.
RECIRC B Recirculates internal air.
Air Mix Control Damper MAX COLD - MAX HOT C, D, E Varies mixture ratio of cool air and warm air in order to regulate temperature continuously from HOT to COLD.
Mode Damper FACE
Y132628

F, K Air blows out of the center registers and side register.
BI-LEVEL
Y132629

F, J Air blows our of the center registers, side registers and foot well register ducts.
FOOT
Y132630

G, I Air blows out of the foot well register ducts and side register. In addition, air blows out slightly from the front defroster.
FOOT/DEF
Y132631

H, I Defrosts the windshield through the front defroster and side register, while air is also blown out from the foot well register ducts.
DEF
Y132632

H, K Defrosts the windshield through the front defroster and side register.


AIR OUTLETS AND AIR FLOW VOLUME


Y113428
4.115,2.281 4.385,2.552 0.271,0.271 10 true A 1.323,1.625 1.583,1.885 0.26,0.26 10 false B 5.24,2.354 5.542,2.635 0.302,0.281 10 false B 2.646,3 2.927,3.271 0.281,0.271 10 false C 4.604,3.573 4.854,3.865 0.25,0.292 10 false C 3.74,0.052 3.906,0.229 0.167,0.177 10 false D 4.542,0.146 4.708,0.323 0.167,0.177 10 false D 5.365,0.313 5.531,0.49 0.167,0.177 10 false D 2.781,2.031 3.052,2.302 0.271,0.271 10 true A

Indication Mode A B C D
Center Side Footwell Defroster
Y132628

FACE
E269229

E269229

- -
Y132629

BI-LEVEL
E269228

E269228

E269226

-
Y132630

FOOT -
E269226

E269228

E269226

Y132631

FOOT/DEF -
E269226

E269228

E269228

Y132632

DEF -
E269226

-
E269228


HINT:
·

The circle size (○) is proportional to the amount of air flow.

·

The same system is used for LHD and RHD vehicles.