Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)
RM1880E _58 Vehicle Interior _013245 HEATING / AIR CONDITIONING _0068660 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) D

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  DTC CHECK / CLEAR  


CHECK INDICATOR


a.
E228748

Turn the ignition switch to ON while pressing the air conditioning control AUTO and recirculation switches simultaneously.


b.
E228749
0.208,2.177 0.531,2.479 0.323,0.302 10 false *a 2.917,2.51 3.24,2.813 0.323,0.302 10 false *e 0.958,2.823 1.271,3.115 0.313,0.292 10 false *d 1.865,2.823 2.167,3.135 0.302,0.313 10 false *d 0.427,3.333 0.74,3.635 0.313,0.302 10 false *b 0.438,3.979 0.708,4.26 0.271,0.281 10 false *c
*a Blinking Pattern
*b On
*c Off
*d 1 sec.
*e 4 times


Check that the indicators turn on and off 4 times at 1 second intervals.

HINT:

After the indicator check is completed, the system enters the DTC check mode automatically.




CHECK DTC (SENSOR CHECK)


a.
E228750
1.448,0.323 1.865,1.271 true 1.313,0.156 1.708,0.458 0.396,0.302 10 false *a
*a Diagnostic Trouble Code (DTC)


After the indicator check is completed, check that the system enters the DTC check mode automatically.

HINT:
·

Press the OFF switch to cancel the check mode.

·

In the sensor check mode, troubleshooting may be only partially completed. Be sure to perform the actuator check, and then perform the sensor check again.




b.

Read the DTCs displayed on the panel (temperature display). Refer to the list of DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)>DIAGNOSTIC TROUBLE CODE CHART) when reading the codes.


c.

If manual switching of the DTC display is desired, press the front DEF switch. This will stop the automatic progression of the DTC display. The DTC display can then be advanced manually by pressing the front DEF switch.



CLEAR DTC


a.

There are 2 methods for clearing the DTC memory.

i.
E228751

During sensor check, press the front DEF switch and rear DEF switch at the same time.


ii.
E225626
1.156,2.313 1.729,2.823 true 0.99,2.198 1.302,2.5 0.313,0.302 10 false *2 0.083,0.083 0.385,0.375 0.302,0.292 10 false *1
*1 Engine Room Relay Block and Junction Block Assembly
*2 ECU-B NO.2 Fuse


Remove the ECU-B NO.2 fuse from the engine room relay block and junction block assembly for 20 seconds or more.