Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)
RM1880E _58 Vehicle Interior _013245 HEATING / AIR CONDITIONING _0068661 AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) U

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)  TERMINALS OF ECU  


CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY


I100991
3.651,0.36 3.982,0.6 0.33,0.24 10 G34 3.609,0.31 3.958,0.548 0.348,0.238

a.

Disconnect the G34 air conditioning amplifier assembly connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
G34-10 (IG+) - G34-18 (GND) R-L - L Ignition power supply Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
G34-18 (GND) - Body ground L - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.



c.

Reconnect the G34 air conditioning amplifier assembly connector.


d.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
G34-1 (MGC) - G34-18 (GND) L-Y - L Cooler compressor assembly operation signal
·

Engine idling

·

Blower switch LO level

·

Cooler switch off or cooler switch on (magnet clutch on not permitted)


11 to 14 V
·

Engine idling

·

Blower switch LO level

·

Cooler switch on (magnet clutch on permitted)


Below 1 V
G34-2 (ACT) - G34-18 (GND) R-L - L Magnet clutch on permit signal
·

Engine idling

·

Blower switch LO level

·

Cooler switch on (magnet clutch on)


5 to 6 V
·

Engine idling

·

Blower switch LO level

·

Cooler switch off or on (magnet clutch off)


Below 1 V
G34-3 (PSW) - G34-18 (GND) Y-B - L Air conditioner pressure sensor signal
·

Engine idling

·

Refrigerant pressure normal


Below 1 V
·

Engine idling

·

Refrigerant pressure abnormal (below 0.176 MPa [1.8 kgf/cm2, 25.5 psi] or higher than 3.025 MPa [30.9 kgf/cm2, 438.6 psi])


11 to 14 V
G34-4 (ACON) - G34-18 (GND) R-G - L Cooler switch signal
·

Engine idling

·

Blower switch LO level

·

Cooler switch off


11 to 14 V
·

Engine idling

·

Blower switch LO level

·

Cooler switch on


Below 1 V
G34-7 (TE) - G34-8 (SG-1) G - P No. 1 cooler thermistor signal
·

Ignition switch ON

·

Evaporator temperature 0°C (32°F)


2.0 to 2.4 V
·

Ignition switch ON

·

Evaporator temperature 15°C (59°F)


1.1 to 1.5 V
G34-8 (SG-1) - Body ground P - Body ground Ground for No. 1 cooler thermistor Always Below 1 Ω
G34-13 (IND-) - G34-18 (GND) R-L - L Cooler switch indicator signal
·

Engine idling

·

Blower switch LO level

·

Cooler switch off or cooler switch on


11 to 14 V
·

Engine idling

·

Blower switch LO level

·

Cooler switch on


Below 1 V
G34-14 (AC1) - G34-18 (GND) Y - L Idle-up request signal
·

Engine idling

·

Blower switch LO level

·

Cooler switch off or cooler switch on


11 to 14 V
·

Engine idling

·

Blower switch LO level

·

Cooler switch on


Below 1 V

If the result is not as specified, the air conditioning amplifier assembly may have a malfunction.




CHECK ECM


E170985
1.658,0.103 1.936,0.26 0.278,0.157 10 C75 1.585,0.062 1.982,0.291 0.397,0.229 2.955,0.103 3.239,0.26 0.284,0.157 10 C76 2.881,0.062 3.278,0.291 0.397,0.229 4.251,0.103 4.583,0.26 0.332,0.157 10 G88 4.177,0.062 4.574,0.291 0.397,0.229 5.543,0.103 5.849,0.26 0.306,0.157 10 G89 5.473,0.062 5.87,0.291 0.397,0.229

a.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
G88-24 (AC1) - C75-3 (E1) Y - BR Idle-up request signal
·

Engine idling

·

Blower switch LO level

·

Cooler switch on


Below 1 V
·

Engine idling

·

Blower switch LO level

·

Cooler switch off


11 to 14 V
G88-25 (ACT) - C75-3 (E1) R-L - BR Magnet clutch on permit output signal
·

Engine idling

·

Blower switch LO level

·

Cooler switch off or on (magnet clutch off)


Below 1 V
·

Engine idling

·

Blower switch LO level

·

Cooler switch on (magnet clutch on)


11 to 14 V

If the result is not as specified, the ECM may have a malfunction.