Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY (for Manual Air Conditioning System)
2.REMOVE AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)
Detach the 3 claws and remove the air mix damper control cable sub-assembly.
3.REMOVE HEATER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)
Detach the 3 claws and remove the heater control cable sub-assembly.
4.REMOVE AIR MIX DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
Remove the 3 screws and air mix damper servo sub-assembly.
5.REMOVE MODE DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
| *1 | Lever |
Detach the claw and remove the lever.
Remove the 3 screws and mode damper servo sub-assembly.
6.REMOVE BLOWER ASSEMBLY
7.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
Remove the screw and heater radiator unit subassembly.
8.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
Remove the 4 screws.
Detach the 3 claws and remove the lower heater case.
Detach the clamp and remove the No. 1 cooler evaporator sub-assembly.
9.REMOVE COOLER EXPANSION VALVE
Using a 4 mm socket hexagon wrench, remove the 2 hexagon bolts.
Remove the cooler expansion valve and 2 O-rings from the cooler evaporator.
10.REMOVE NO. 1 COOLER THERMISTOR