Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT AIR CONDITIONING UNIT
RM1880E _58 Vehicle Interior _013245 HEATING / AIR CONDITIONING _0068664 FRONT AIR CONDITIONING UNIT A

HEATING / AIR CONDITIONING  FRONT AIR CONDITIONING UNIT  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 2.INSTALL COOLER EXPANSION VALVE

a.

Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.

Compressor oil:

ND-OIL 8 or equivalent



b.

Install the 2 O-rings to the cooler evaporator.


c.

Using a 4 mm socket hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.

Torque:
3.5 N*m (35 kgf*cm, 30 in.*lbf)


Hide 3.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

a.

Attach the clamp to install the No. 1 cooler evaporator sub-assembly.


b.

Attach the 3 claws to install the lower heater case.


c.

Install the 4 screws.


Hide 4.INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY

a.

Attach the evaporator case to the blower case.


b.

Install the heater radiator unit sub-assembly with the screw.


Hide 6.INSTALL HEATER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)

a.

Attach the 3 claws to install the heater control cable sub-assembly.


Hide 7.INSTALL AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)

a.

Attach the 3 claws to install the air mix damper control cable sub-assembly.


Hide 8.INSTALL MODE DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)

a.

Install the mode damper servo sub-assembly with 3 screws.


b.
E225046
0.781,0.698 1.542,0.229 1.542,0.229 2.219,0.677 true 1.458,0.042 1.823,0.354 0.365,0.313 10 false *a
*a Cut Part


Set the mode damper servo sub-assembly so that the tooth of the gear engages with the cutout part as shown in the illustration to install the lever.


c.

Attach the claw to install the lever.


Hide 9.INSTALL AIR MIX DAMPER SERVO SUB-ASSEMBLY

a.

Install the air mix damper servo sub-assembly with the 3 screws.


Hide 10.INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY (for Manual Air Conditioning System)