1.INSTALL REAR COOLING UNIT EXPANSION VALVE
Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the evaporator sub-assembly joint.
ND-OIL 8 or equivalent
Install the 2 O-rings to the evaporator sub-assembly.
Install the rear cooling unit expansion valve to the evaporator sub-assembly.
2.INSTALL AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the air conditioning tube and accessory assembly joint.
ND-OIL 8 or equivalent
Install the 2 O-rings to the air conditioning tube and accessory assembly.
Using a 4 mm socket hexagon wrench, install the air conditioning tube and accessory assembly to the evaporator with the 2 hexagon bolts.
Attach the 3 claws to install the cooling unit case (motor side).
Install the 9 screws.
3.INSTALL REAR BLOWER MOTOR WITH FAN SUB-ASSEMBLY
Install the rear blower motor with fan sub-assembly with the 3 screws.
4.INSTALL NO. 2 COOLER UNIT DRAIN HOSE
Install the No. 2 cooler unit drain hose.
5.INSTALL BLOWER (REAR) RESISTOR