Home › Vehicle Interior › HEATING / AIR CONDITIONING › BLOWER RESISTOR(for Rear Side)
RM1880E _58 Vehicle Interior _013245 HEATING / AIR CONDITIONING _0068670 BLOWER RESISTOR(for Rear Side) G

HEATING / AIR CONDITIONING  BLOWER RESISTOR(for Rear Side)  INSPECTION  


PROCEDURE

Hide 1.INSPECT BLOWER (REAR) RESISTOR

E228821
1.01,0.813 1.521,1.063 true 2.302,0.813 1.906,1.073 true 2.375,1.458 1.927,1.302 true 0.094,0.063 0.313,0.26 0.219,0.198 10 false *a 2.354,0.719 2.729,0.917 0.375,0.198 10 false HI 2.438,1.396 2.833,1.594 0.396,0.198 10 false M2 0.76,0.708 1.198,0.875 0.438,0.167 10 false M1
*a Component without harness connected
(Blower (Rear) Resistor)


a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Always 1.49 to 1.67 Ω
1 - 3 Always 0.52 to 0.60 Ω
1 - 4 Always 3.12 to 3.60 Ω


If the result is not as specified, replace the blower (rear) resistor.