Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR
RM1880E _58 Vehicle Interior _013245 HEATING / AIR CONDITIONING _0068671 COMPRESSOR A

HEATING / AIR CONDITIONING  COMPRESSOR  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE COOLER BRACKET

a.
E172838

for LHD:

i.

Detach the clamp.


ii.

Remove the screw and cooler bracket.



b.
E171844

for RHD:

i.

Detach the clamp.


ii.

Remove the screw and cooler bracket.



Hide 2.REMOVE MAGNET CLUTCH ASSEMBLY

a.
E172839
1.625,2.406 1.052,2.979 true 0.917,3.01 1.25,3.208 0.333,0.198 10 false SST

for LHD:

i.

Clamp the cooler compressor in a vise between aluminum plates.


ii.

Using SST, hold the magnet clutch hub.

SST
09985-00270  


iii.

Remove the bolt, magnet clutch hub and magnet clutch washer(s).

HINT:

There is no set number of magnet clutch washers since they are used for adjusting.




b.

for RHD:

i.
E171831
1.328,2.732 1.503,2.953 0.175,0.221 10 *1 1.51,2.823 2.41,2.823 false
*1 Battery


Clamp the cooler compressor in a vise between aluminum plates.


ii.

Connect the battery to the magnet clutch assembly as shown in the illustration to fix the hub and rotor in place.


iii.

Wrap the drive belt around the rotor and securely hold it in place by hand.


iv.

Remove the bolt, magnet clutch hub and magnet clutch washer(s).

HINT:

There is no set number of magnet clutch washers since they are used for adjusting.




c.
E155202

Using a snap ring expander, remove the snap ring and magnet clutch rotor.

NOTICE:

Do not damage the seal cover of the bearing when removing the snap ring.



d.
E155203

Using a snap ring expander, remove the snap ring and magnet clutch stator.