Home › Vehicle Interior › HEATING / AIR CONDITIONING › ROOM TEMPERATURE SENSOR(for Automatic Air Conditioning System)
RM1880E _58 Vehicle Interior _013245 HEATING / AIR CONDITIONING _0068673 ROOM TEMPERATURE SENSOR(for Automatic Air Conditioning System) G

HEATING / AIR CONDITIONING  ROOM TEMPERATURE SENSOR(for Automatic Air Conditioning System)  INSPECTION  


PROCEDURE

Hide 1.INSPECT COOLER THERMISTOR

E272049
0.167,1.688 0.479,1.99 0.313,0.302 10 false *b 1.802,4.292 2.115,4.594 0.313,0.302 10 false *c 0.125,0.063 0.438,0.365 0.313,0.302 10 false *a
*a Component without harness connected
(Cooler Thermistor (Room Temperature Sensor))
*b Resistance kΩ
*c Temperature °C (°F)


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 10°C (50°F) 3.00 to 3.73 kΩ
15°C (59°F) 2.45 to 2.88 kΩ
20°C (68°F) 1.95 to 2.30 kΩ
25°C (77°F) 1.60 to 1.80 kΩ
30°C (86°F) 1.28 to 1.47 kΩ
35°C (95°F) 1.00 to 1.22 kΩ
40°C (104°F) 0.80 to 1.00 kΩ
45°C (113°F) 0.65 to 0.85 kΩ
50°C (122°F) 0.50 to 0.70 kΩ
55°C (131°F) 0.44 to 0.60 kΩ
60°C (140°F) 0.36 to 0.50 kΩ


NOTICE:
·

Touching the sensor even slightly may change the resistance value. Hold the connector of the sensor.


·

When measuring the resistance, the sensor temperature must be the same as the ambient temperature.



HINT:

As the temperature increases, the resistance decreases (refer to the graph).


If the result is not as specified, replace the cooler thermistor (room temperature sensor).