1.INSTALL NO. 1 PRESSURE SWITCH
Remove the attached vinyl tape from the No. 1 pressure sensor (air conditioning pressure sensor).
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the No. 1 pressure sensor (air conditioning pressure sensor).
Keep the O-ring and O-ring fitting surface free from dirt and foreign objects.
ND-OIL 8 or equivalent
Using a 27 mm deep socket wrench, install the No. 1 pressure switch (air conditioning pressure sensor).
Connect the connector.
2.CHARGE REFRIGERANT
3. WARM UP ENGINE
4.CHECK FOR REFRIGERANT GAS LEAK