Home › Vehicle Interior › HEATING / AIR CONDITIONING › REAR BLOWER CONTROL SWITCH
RM1880E _58 Vehicle Interior _013245 HEATING / AIR CONDITIONING _0068680 REAR BLOWER CONTROL SWITCH G

HEATING / AIR CONDITIONING  REAR BLOWER CONTROL SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT COOLER CONTROL SWITCH ASSEMBLY

a.
E128900
1.375,0.948 1.375,1.427 true 1.375,1.427 0.854,1.427 false 0.854,1.427 0.854,1.719 true 1.563,0.969 1.563,1.531 true 1.563,1.531 1.25,1.531 true 1.25,1.531 1.25,1.75 false 1.708,0.948 1.708,1.74 true 1.875,0.958 1.875,1.552 true 1.875,1.552 2.177,1.552 false 2.177,1.563 2.177,1.771 false 2.063,0.969 2.063,1.427 true 2.063,1.427 2.594,1.427 false 2.594,1.438 2.594,1.76 true 0.646,1.781 1.031,2.021 0.385,0.24 10 false OFF 1.177,1.76 1.427,2.042 0.25,0.281 10 false LO 1.615,1.792 1.896,1.969 0.281,0.177 10 false M1 2.083,1.802 2.406,2.042 0.323,0.24 10 false M2 2.542,1.823 2.844,2.031 0.302,0.208 10 false HI 0.083,0.021 0.292,0.229 0.208,0.208 10 false *a
*a Component with harness connected
(Cooler Control Switch Assembly (Rear Blower Control Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 - 4 LO Below 1 Ω
5 - 4
5 - 3
M1 Below 1 Ω
5 - 4
5 - 2
M2 Below 1 Ω
5 - 4
5 - 1
HI Below 1 Ω


If the result is not as specified, replace the cooler control switch assembly (rear blower control switch).