1.INSPECT REAR COOLER RELAY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 - 4 | Battery voltage not applied to terminals 3 and 5 | Below 1 Ω |
| 1 - 2 | Battery voltage not applied to terminals 3 and 5 | 10 kΩ or higher |
| Battery voltage applied to terminals 3 and 5 | Below 1 Ω |
If the result is not as specified, replace the rear cooler relay.