Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.REMOVE AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)
Detach the 3 claws and remove the air inlet damper control cable sub-assembly.
2.REMOVE RECIRCULATION DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
| *1 | Lever |
Detach the claw and remove the lever.
Remove the 3 screws and recirculation damper servo sub-assembly.
3.REMOVE CLEAN AIR FILTER
Detach the claw and remove the air filter case.
Remove the clean air filter.
4.REMOVE BLOWER RESISTOR (for Manual Air Conditioning System)
5.REMOVE BLOWER MOTOR CONTROL (for Automatic Air Conditioning System)
6.REMOVE BLOWER MOTOR WITH FAN SUB-ASSEMBLY